K&E Safety M490-LED DCBP Blue Strobe Light Kit
Blue LED strobe kit with three flash rates, IP67 rating and 26,000-hour lamp life
- Blue LED strobe delivers high visibility
- Three flash rates — 63, 80 or 120 per minute
- IP67 rating resists dust and water ingress
- Operates from 12 to 90 V DC power sources
- Long-life LED rated for 26,000 hours of use
Product Overview
The K&E Safety M490-LED DCBP is a blue LED strobe light kit designed for warning and signalling applications. It operates on a wide 12 to 90V DC power range, drawing between 0.18 and 0.24 amps. The unit is rated IP67 for dust and water ingress protection.
Build Integration
The light features a screw mounting base and requires a wired DC power source within the specified voltage range. Its ABS housing and polycarbonate dome lens suit interior or exterior mounting where a 3 by 3 inch footprint is available. The wide voltage input frees the installer from needing a specific regulated supply.
Thermals and Power
The LED lamp is rated for a 26,000 hour service life. The unit functions across an operating temperature span of -30 to 50 degrees Celsius. With a low current draw of 0.18 to 0.24 amps, it imposes minimal load on the electrical system during continuous flashing operation.
How it compares
Measured against everything we stock in LED Lighting Kits, at today’s prices. Recalculated every night.
- Price $58.99
- Pricier than about 71% of the 1,591 comparable items (median $33.99).
Specifications
| Product | |
|---|---|
| Brand name | RAILHEAD GEAR |
Questions about this item
Does the 12-90V DC input limit how long the M490-LED DCBP can run continuously?
The unit is rated for continuous operation from -30 to 50 °C with an IP67 housing, so the voltage range itself does not impose a run-time limit.
How much heat or noise does the strobe produce when powered all day at 0.18-0.24 A?
LED lamp draws 0.18 to 0.24 A, runs silently with no moving parts, and the ABS housing stays cool enough for the full -30 to 50 °C ambient range.
What mounting hardware must I already have to install the screw-mount base?
The kit uses a screw mount; you need a flat surface and the appropriate screws or bolts for that surface, which are not included.
More in LED Lighting Kits
Similar items
WhilsTec W13739 Light Kit 4 Pack Oak Yellow
- Walnut - WhilsTec
- WhilsTec Rechargeab…
Unique-Bargains 4-Pin 10mm Male-to-Male LED Connector Black
DESIGNERS EDGE L6020WH Motion Sensor 180 Degree 70 ft White
AILBTON DT2-60 Light Kit 100ft 5050 RGB Bluetooth App IR Remote Mic Music Sync 12V 12W
- AILBTON DT2-60
- AILBTON





