We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Two small circuit boards with HDMI ports and 15-pin 60mm flat cables attached

KEHIPI

KEHIPI CSI to HDMI Extension Module 15pin 60mm FPC Cable Pack of 2

SKU CH-B24B-400DK

Extends Raspberry Pi and Jetson camera signals up to 5 metres using standard HDMI cable and includes a 15-pin 60 mm FPC link

  • Product colorFor Rpi Camera V1 V2
  • Extends Raspberry Pi cameras up to 10 meters using standard HDMI cable
  • Includes two 15-pin 60 mm FPC cables for direct camera connection
  • Supports Pi Camera V1, V2, V3 and HQ modules
  • Adds three auxiliary signals via headphone jack for GPIO or audio
  • Compatible with Raspberry Pi 4B, 3B+, 3B, 2, Zero and Jetson Orin Nano

CSI-HDMI Camera Extension Module

This KEHIPI CSI to HDMI extension module adapts Raspberry Pi camera V1, V2, V3 and HQ modules to standard HDMI cabling. Two adapter boards and two 15-pin 60 mm FPC cables are included, allowing the CSI signal to travel over longer high-speed HDMI links. The boards also carry three extra signals through a headphone jack connector for audio, GPIO or sensor use. Supported hosts include Raspberry Pi 4B, 3B+, 3B, 2, Model A/B/B+, Pi Zero and NVIDIA Jetson Orin Nano.

Makers needing longer camera runs

Builders who want to place a Pi camera several metres from the board benefit from the noise-resistant HDMI extension and the three auxiliary channels. Users whose cameras must stay within the short native FPC length, or who prefer a direct CSI-to-CSI ribbon, will not need this adapter set. The module does not add any image processing or compression; it only transports the existing CSI stream.

15-pin 60 mm FPC cable included

Each kit supplies two 15-pin 60 mm flexible flat cables that mate directly with the camera module and the adapter board. If your camera uses a different pin count or pitch, the supplied FPCs will not connect.

How it compares

Measured against everything we stock in Shutter Remotes & Camera Cables, at today’s prices. Recalculated every night.

Price $18.99
Typical for this category: the median of 249 items is $17.99.

Specifications

Product
Brand nameArducam
Product colorFor Rpi Camera V1 V2

Questions about this item

How do I decide between the V1, V2, V3 and HQ camera versions this module supports?

The module works with all four camera boards — V1 (5MP OV5647), V2 (8MP IMX219), V3 (12MP IMX477) and HQ (12MP IMX477) — so choose the camera that matches your resolution and sensor needs; the adapter itself is identical for each.

What does running the camera over 10 metres with a high-speed HDMI cable mean in practice?

It means the CSI signals are converted to travel over a standard HDMI cable up to 10 metres without signal loss, letting you place the camera far from the Raspberry Pi or Jetson board while keeping full bandwidth.

What does the headphone-jack connector on the board add to the HDMI extension?

It carries three extra signals — such as audio, GPIO or other sensor lines — alongside the video stream so you can extend more than just the camera data over the same cable.

More in Shutter Remotes & Camera Cables

Similar items