Rosewill RMS-E53 triple monitor mount 15-27" 17.6lb gas spring VESA 75/100 clamp grommet monitor accessory
- Monitor Arms
- Black
We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.
Replacement screen for HP 17-BY2091NR with 30-pin connector and 1600x900 glossy HD+ panel
This LCDBros panel is a direct replacement for the HP 17-BY2091NR laptop display. It restores the original 1600x900 HD+ resolution on a 17-inch form factor. The glossy finish matches the factory screen surface. Buyers who need a different resolution, a matte coating or a touch-enabled layer cannot use this part.
The screen connects through a 30-pin interface that aligns with the HP 17-BY2091NR motherboard header. A glossy surface delivers vivid colour reproduction in controlled lighting but reflects ambient light in bright rooms. The package contains the panel only; no hinges, brackets, bezel or webcam module are included. Installers must reuse the original mounting hardware and cable routing.
This unit replaces a damaged, dead-pixel or backlight-failed original screen with a 100-per-cent compatible alternative. The swap is worthwhile when the laptop chassis and system board remain functional. It is not a resolution upgrade — 1600x900 is the native maximum — and it does not add touch input. Match the exact model number before ordering to avoid fitment issues.
Measured against everything we stock in Monitor Mounts & Display Accessories, at today’s prices. Recalculated every night.
| Product | |
|---|---|
| Brand name | LCDBros |
| Model name | HP 17-BY2091NR |
| Product type | Replacement Screen |
The 30-pin connector carries a 1600x900 HD+ signal; the panel will not operate at any other resolution.
The 17-inch diagonal, 30-pin bottom connector placement, and original bracket hole pattern must be identical to the factory panel.
Disconnect power and battery, remove the bezel, swap the 30-pin cable into the new panel, then test the display before reattaching the bezel.
More in Monitor Mounts & Display Accessories
What you pay in, and what you read prices in.
Sent from your wallet at checkout
Display only — the catalogue is priced in USD
No currency matches that.
New here?
Already have one?
There is no automatic reset: this shop sends no mail, so there is no one-time link to ask for. Leave the address on the account and it gets picked up by hand.
Request noted
Nothing is on its way to your inbox — this shop sends no mail at all. Someone picks these up by hand.
Remembered it?