We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Chrome-plated brass pipe nipple, 1/2 inch diameter, 4-1/2 inches long, shiny silver finish

Legend Valve

Legend Valve 311-067CNL 1/2" x 4-1/2" Chrome Nipple NL trap

SKU CH-3407-WYZB6

A 1/2 inch by 4-1/2 inch no-lead chrome plated brass pipe nipple for plumbing drain and trap connections

  • Product colorTransparent
  • No-lead brass protects drinking water safety
  • Chrome plating resists corrosion for long service
  • 1/2-inch thread fits standard plumbing connections
  • 4-1/2-inch length suits common trap installations
  • New condition ensures clean, undamaged threads

Plumbing nipple for drain connections

This 1/2" x 4-1/2" chrome-plated brass nipple connects drain and trap components in plumbing installations. The no-lead construction meets Proposition 65 requirements for safer drinking water contact. It suits residential and light-commercial projects where a short, straight connector is needed.

Capacity and headroom for flow

The 1/2" bore handles typical sink, lavatory and fixture drainage without restriction. Length of 4-1/2" provides enough reach for standard trap-to-wall or trap-to-floor alignments. Chrome-plated brass resists corrosion in wet environments but is not rated for pressurised supply lines or high-temperature discharge.

Threaded interface practical limits

Male NPT threads on each end accept standard 1/2" female fittings such as trap adapters, couplings or wall elbows. Brass threads gall if overtightened, so hand-tight plus one turn with a wrench is the practical limit. The fitting is not intended for gas service, fuel lines or any application outside gravity drainage.

How it compares

Measured against everything we stock in Drain Stoppers, Strainers & Traps, at today’s prices. Recalculated every night.

Price $9.99
Cheaper than about 84% of the 4,240 comparable items (median $31.99).

Specifications

Product
Brand nameLEGEND VALVE
Product colorTransparent

Questions about this item

Will the 1/2" chrome nipple connect to my existing 1/2" brass fittings without adapters?

Yes, the 1/2" threads match standard 1/2" brass fittings so it threads directly onto the pipes you already have.

How can I confirm the nipple is seated correctly after installation?

Tighten until the chrome body sits flush against the fitting faces and no threads show; then run water and check the joint for drips.

Does the box include thread sealant or do I need to buy pipe tape separately?

Only the chrome plated brass nipple is supplied; thread seal tape or compound must be purchased separately.

More in Drain Stoppers, Strainers & Traps

Similar items