Ericson Watertight Straight Blade Plug 1616-CW6P-AM 20A 250VAC Yellow
- Yellow
We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.
Watertight locking straight-blade plug rated 125/250 V AC at 20 A with IP67 protection and corrosion-resistant nylon housing
This Legrand straight blade plug is built for industrial environments where moisture and dust are constant hazards. It accepts three-wire cords from .300 to .625 inches in diameter and locks securely into matching receptacles. The nylon housing resists corrosion and meets IP67 ingress protection. Electricians and maintenance crews specify it for temporary power distribution on wet job sites.
The non-shrouded locking blades prevent accidental disconnection when cables are pulled or vibrated. Yellow nylon material provides visibility in low light and withstands repeated insertion cycles without cracking. The plug handles 125/250V AC at 20 amps across three poles and three wires. Its cord-grip range accommodates standard industrial cable sizes without adapters.
This plug follows the L5-15P pinout for three-phase 20-amp service at 125/250 volts. It will not mate with single-phase or 15-amp receptacles, so verify the matching outlet before purchase. The IP67 rating guarantees protection against immersion up to one metre for thirty minutes. Buyers needing a different pole count or voltage rating must select another part number.
Measured against everything we stock in AC Plugs & USB Wall Chargers, at today’s prices. Recalculated every night.
| Product | |
|---|---|
| Brand name | LEGRAND |
| Size & build | |
| Main material | HAWA |
The plug is rated for 125/250V AC and uses the L5-15P locking configuration, which is standard for 125V 15A circuits; the 250V rating applies to the device construction but the L5-15P blade pattern only fits 125V receptacles.
The cord grip accommodates cables from 0.300 in to 0.625 in outer diameter, so the jacket must fall within that window to seal to IP67.
Insert the stripped conductors into the terminal screws, tighten to the specified torque, then thread the gland nut until the internal gasket compresses evenly around the cable; the step often missed is fully seating the gasket before final tightening.
More in AC Plugs & USB Wall Chargers
What you pay in, and what you read prices in.
Sent from your wallet at checkout
Display only — the catalogue is priced in USD
No currency matches that.
New here?
Already have one?
There is no automatic reset: this shop sends no mail, so there is no one-time link to ask for. Leave the address on the account and it gets picked up by hand.
Request noted
Nothing is on its way to your inbox — this shop sends no mail at all. Someone picks these up by hand.
Remembered it?