We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Silver 5.0 mm 4-flute ball nose end mill, model 14019680A

M.A. Ford

M.A. Ford 14019680A Tuffcut GP 4 Flute Ball Nose End Mill 5.0 mm pneumatic accessory

SKU CH-P6XM-JENKG

Four-flute ball-nose end mill cuts 5.0 mm radii in general-purpose milling

  • 4-flute ball nose cuts complex contours smoothly
  • 0 mm diameter fits precise milling tasks
  • Tuffcut GP design handles general-purpose machining
  • M.A. Ford brand signals professional tool quality
  • New condition ensures full cutting performance

Tool identity

The M.A. Ford 14019680A Tuffcut GP is a four-flute ball nose end mill with a 5.0 mm cutting diameter. It is manufactured for CNC milling operations that require contoured or radiused profiles in metal workpieces.

Upgrade scope

This cutter replaces worn or lower-flute ball nose tools when finish quality or tool life becomes insufficient. The step up is justified when a machinist needs the rigidity and chip evacuation of a four-flute design for profiling passes in steel or alloy.

Installation notes

The shank fits standard ER collets or end mill holders matching the tool diameter. Run-out should be checked after clamping because excessive eccentricity accelerates wear on the ball nose radius. Verify coolant delivery reaches the cutting zone to avoid built-up edge on stainless or titanium.

How it compares

Measured against everything we stock in Bits, Hole Saws & Accessory Kits, at today’s prices. Recalculated every night.

Price $27.99
Typical for this category: the median of 5,493 items is $27.99.

Specifications

Product
Brand nameM.A. FORD

Questions about this item

What shank diameter does the 5.0 mm Tuffcut GP end mill need in a collet or holder?

Use a 5.0 mm collet or shrink-fit holder that matches the shank; clean both surfaces before clamping to avoid runout.

How do you install the 4-flute ball nose cutter without damaging the flutes?

Insert the tool shank fully into the collet, tighten the nut to the holder’s rated torque, and never tap the flutes with a hammer.

When should the 14019680A ball nose end mill be replaced or resharpened?

Replace or send for regrind when the ball radius shows visible wear, cutting edges chip, or surface finish degrades on the workpiece.

More in Bits, Hole Saws & Accessory Kits

Similar items