We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Silver 1/2 inch ball nose end mill with four spiral flutes

M.A. Ford

M.A. Ford 14050000T Tuffcut GP 4 Flute Ball Nose End Mill 1/2 in pneumatic accessory

SKU CH-QTD9-SWNA3

Four-flute ball-nose end mill 14050000T cuts contoured profiles in 1/2 in milling operations

  • 4-flute ball nose design enables smooth contour milling
  • 1/2 inch diameter suits standard tool holders
  • M.A. Ford manufacturing ensures consistent cutting performance
  • TuffCut GP series built for general-purpose machining
  • California Proposition 65 warning indicates regulated material content

M.A. Ford 14050000T End Mill

The M.A. Ford 14050000T Tuffcut GP is a 4-flute ball nose end mill designed for general-purpose milling operations. It suits machinists and maintenance professionals who need a reliable cutting tool for profiling and contouring tasks. The tool is supplied new and ships directly from the manufacturer. California Proposition 65 warnings apply regarding chemical content.

Machinists needing ball nose profiling

This cutter suits operators performing 3D contouring, pocketing or finishing passes where a ball nose geometry is required. It is not intended for buyers who need a square end mill for flat-bottom cavities or a roughing tool with chip-breaker geometry. Users requiring a different flute count, diameter or coating should select an alternative tool. The Proposition 65 notice indicates the presence of listed chemicals.

Standard tool holder installation

The end mill installs into a compatible tool holder or collet using standard clamping procedures for shank-type cutters. Ensure the holder is clean and the tool is secured to the correct projection length. Common issues include excessive runout from worn collets or insufficient clamping force, which can cause vibration and poor surface finish. Improper feed and speed settings may also lead to premature wear or tool breakage.

How it compares

Measured against everything we stock in Bits, Hole Saws & Accessory Kits, at today’s prices. Recalculated every night.

Price $93.99
Pricier than about 82% of the 5,493 comparable items (median $27.99).

Specifications

Product
Brand nameM.A. FORD

Questions about this item

What milling machine or collet system accepts a 1/2 in shank end mill?

A milling machine or router with a 1/2 in collet or chuck is required to hold the 14050000T end mill securely during operation.

Can the 14050000T be used in the same setup as older high-speed steel ball nose cutters?

Yes, it fits the same 1/2 in tool holders, but the carbide Tuffcut GP design typically runs at higher speeds and feeds than older HSS cutters, so adjust parameters accordingly.

How do I verify the 14050000T is cutting correctly after installation?

Check for a smooth, chatter-free finish on the workpiece, consistent chip formation, and measure the finished radius to confirm the ball nose profile matches the programmed path.

More in Bits, Hole Saws & Accessory Kits

Similar items