We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Small silver ball-nose end mill with two flutes, 0.80 mm diameter

M.A. Ford

M.A. Ford 15003150 Tuffcut GP 2-flute ball nose end mill 0.80 mm pneumatic accessory

SKU CH-WYP7-YSJFW

Two-flute ball nose end mill cuts contoured profiles in a range of materials

  • Precision ball nose for smooth contouring
  • Two-flute design clears chips efficiently
  • 80 mm diameter suits fine detail work
  • M.A. Ford Tuffcut GP series built for durability
  • California Proposition 65 warning applies

Product identification

The M.A. Ford 15003150 Tuffcut GP is a 2-flute ball nose end mill with a 0.80 mm diameter. It belongs to the Power & Pneumatic Accessories range and is supplied new. The tool is manufactured by M.A. Ford and ships directly from the maker.

Who this suits and who it does not

Machinists needing a small-diameter ball nose cutter for contouring and finishing operations will find this end mill suitable. It is not intended for users requiring a larger cutting diameter, a different flute count, or a flat-end profile for their milling tasks.

Critical specification

The 0.80 mm cutting diameter is the single dimension that determines whether this tool fits the programmed toolpath and workpiece requirements. Verify this measurement against your CAM setup before ordering. California Proposition 65 warnings apply to this product.

How it compares

Measured against everything we stock in Bits, Hole Saws & Accessory Kits, at today’s prices. Recalculated every night.

Price $23.99
Cheaper than about 57% of the 5,493 comparable items (median $27.99).

Specifications

Product
Brand nameM.A. FORD

Questions about this item

Will this 0.80 mm ball nose end mill fit the collet on my existing pneumatic die grinder?

The cutter has a 0.80 mm cutting diameter; you need a collet or chuck that accepts that shank size for it to run true.

Does the 2-flute geometry on this 0.80 mm tool clear chips fast enough when I keep my older low-RPM pneumatic grinder?

Two flutes give more chip space than multi-flute cutters, so even at modest speeds the tool evacuates material without packing.

How can I verify the 15003150 end mill is cutting correctly after I install it?

Check for a smooth, chatter-free finish on the workpiece and measure the radius to confirm the ball nose profile is accurate.

More in Bits, Hole Saws & Accessory Kits

Similar items