M.A. Ford 15007090 Tuffcut GP 2-flute ball nose end mill 1.8 mm pneumatic accessory

M.A. Ford Tuffcut GP ball nose end mill

The M.A. Ford 15007090 is a 1.8 mm two-flute ball nose end mill from the Tuffcut GP range. It is a power and pneumatic accessory built for milling operations that require a rounded cutting profile. Machinists and maintenance technicians use it for contouring, slotting and finishing in a variety of materials. The tool is supplied new and ships directly from the manufacturer.

California Proposition 65 chemical warnings

This product carries two California Proposition 65 warnings. One advises that the item contains a chemical known to the state to cause cancer. The other advises that it contains a chemical known to cause birth defects or other reproductive harm. These notices are regulatory disclosures and do not alter the tool's dimensions or cutting geometry. Buyers who must avoid listed substances should review the warnings before purchase.

1.8 mm cutting diameter decides fit

The single specification that determines whether this end mill suits the job is its 1.8 mm cutting diameter. That dimension fixes the minimum radius and the maximum step-over achievable in a single pass. If the design calls for a larger or smaller ball profile, this tool will not meet the requirement. No other size or shank variant is described in the data.