We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Silver 10 mm solid double-margin drill bit with two spiral flutes

M.A. Ford

M.A. Ford CXDSR 1000AP Cyclone Xd 5X Double Margin Drill 10.00Mm

SKU CH-BC5X-63TVX

A solid double-margin drill with 5x diameter depth capacity for 10.00 mm holes

  • 10 mm diameter fits precise hole sizes
  • 5× length-to-diameter ratio reaches deeper holes
  • Double margin design improves hole straightness
  • Cyclone Xd geometry enhances chip evacuation
  • New condition ensures full factory performance

10 mm Cyclone Xd drill bit

The M.A. Ford CXDSR 1000AP is a solid carbide drill bit with a 10.00 mm cutting diameter. It uses a 5× diameter flute length and a double-margin design for improved hole straightness. The tool is intended for high-performance drilling in a variety of materials.

Suited for precision holemaking.

Machinists needing accurate, deep holes in steel, stainless steel or cast iron will benefit from the double-margin geometry. Operations without rigid workholding or through-spindle coolant may not achieve the designed performance. Buyers who require a larger diameter or a different flute length should look at other options.

Fits standard toolholders; frees up cycle time

The straight shank fits common collets and hydraulic holders without special adapters. The 5× length reaches deeper features in a single pass, reducing the need for peck cycles. Ensure the machine spindle provides adequate run-out control for the 10 mm shank.

How it compares

Measured against everything we stock in Bits, Hole Saws & Accessory Kits, at today’s prices. Recalculated every night.

Price $150.99
Pricier than about 90% of the 5,493 comparable items (median $27.99).

Specifications

Product
Brand nameM.A. FORD

Questions about this item

What drill chuck or collet size do I need for the 10.00 mm shank on this drill?

You need a chuck or collet that accepts a 10.00 mm shank. A standard 10 mm or 3/8 inch keyed or keyless chuck will hold it securely.

Will the double-margin design of this 1000AP drill cause issues if I use it in an older drill press with standard runout?

The double-margin design improves hole straightness and finish even on machines with moderate runout, but excessive spindle wobble will still reduce tool life.

After drilling, how can I confirm the Cyclone Xd 5X geometry is producing the expected hole quality?

Measure the finished hole diameter and check for a smooth, consistent surface finish without chatter marks. The double margins should leave a clean, round hole at the 10.00 mm size.

More in Bits, Hole Saws & Accessory Kits

Similar items