M.A. Ford CXDSS 0300AP Cyclone Xd 3mm Solid Double Margin Drill

3 mm Solid Double Margin Drill

The M.A. Ford CXDSS 0300AP Cyclone Xd is a 3.00 mm diameter solid carbide drill built with double margins for improved hole straightness and surface finish. It targets machinists and maintenance technicians who need a short, rigid tool for high-precision drilling in steels, stainless steels and cast irons. The 3X length-to-diameter ratio keeps deflection low in shallow holes. This drill is not suited for deep-hole applications or for operators who require internal coolant delivery through the tool.

Standard Shank Installation

The drill uses a common cylindrical shank that fits directly into ER collets, Weldon flats or hydraulic holders without adapters. Run-out should be checked at the tip after clamping because excessive run-out reduces the double-margin benefit and shortens tool life. The solid carbide body is brittle so avoid side loads and intermittent cuts that can cause chipping. No special torque values or break-in procedures are supplied by the manufacturer.

Machine and Material Check

Verify that your spindle can run at the speeds and feeds recommended for a 3 mm carbide drill in the workpiece material you are cutting. Confirm the holder provides enough clamping force to prevent pull-out at those parameters. Ensure flood coolant or mist can reach the cutting zone because the tool has no through-coolant holes. The product carries a California Proposition 65 warning for chemicals linked to cancer and reproductive harm so handle with appropriate personal protection and ventilation.