We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Silver cylindrical drill bit with spiral flutes and a pointed tip

M.A. Ford

M.A. Ford CXDSS 0750AP 7.50 mm Cyclone Xd 3X Solid Double Margin Drill

SKU CH-X3YG-RTH8X

7.50 mm Cyclone Xd 3X solid double-margin drill for precise deep-hole drilling

  • 50 mm diameter drills precise holes in one pass
  • 3X flute geometry clears chips faster for smoother cuts
  • Solid double margin design keeps the drill centred under load
  • Cyclone Xd coating resists wear for longer tool life
  • New M.A. Ford drill ready for immediate workshop use

7.50 mm Cyclone Xd Drill

The M.A. Ford CXDSS 0750AP is a solid double margin drill built for power and pneumatic tool users. Its 3X design targets controlled holemaking in production and maintenance environments where a 7.50 mm diameter is specified.

Capacity and headroom

The 7.50 mm cutting diameter sets the hole size this tool comfortably produces in a single pass. The double margin geometry adds stability in deeper cuts, but the fixed diameter means it cannot adapt when a different hole size is required.

Thermals noise and power draw

Cutting heat and sound levels depend on the host machine speed feed and workpiece material rather than the drill itself. Power draw is determined by the driving tool and the load applied during the cut.

How it compares

Measured against everything we stock in Bits, Hole Saws & Accessory Kits, at today’s prices. Recalculated every night.

Price $101.99
Pricier than about 83% of the 5,493 comparable items (median $27.99).

Specifications

Product
Brand nameM.A. FORD

Questions about this item

Will the 7.50 mm Cyclone Xd 3X drill fit the same chuck and collet setup I use for other 7.50 mm bits?

Yes, the 7.50 mm shank matches standard 7.50 mm chucks and collets, so it works with your existing holders without adapters.

How can I confirm the double-margin geometry is cutting correctly once installed?

Run a test hole in the target material; consistent chip formation, minimal vibration and a round hole within tolerance show the double margins are guiding properly.

Does the box include any coolant-fed adapters or only the solid carbide drill itself?

The package contains the CXDSS 0750AP solid carbide drill only; coolant-fed adapters, tool holders and collets are sold separately.

More in Bits, Hole Saws & Accessory Kits

Similar items