We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
M.A. Ford DE2B6250 PCD ball end mill 5/8 two flute

M.A. Ford

M.A. Ford DE2B6250 Pcd Ball Em 5/8 2 Flute pneumatic accessory

SKU CH-MS1N-1Q3PD

A 5/8 inch, two-flute PCD ball end mill for precision milling in abrasive materials

  • M.A. Ford quality for reliable pneumatic performance
  • 5/8 inch ball end mill suits detailed profiling
  • Two-flute design clears chips efficiently in soft materials
  • PCD construction resists wear for longer tool life
  • California Proposition 65 notice included for safety awareness

M.A. Ford DE2B6250 PCD Ball End Mill

This M.A. Ford DE2B6250 is a PCD ball end mill with a 5/8 inch diameter and two flutes. It is a power and pneumatic accessory designed for precision milling tasks. The tool is supplied new and ships directly from the manufacturer.

Suited for abrasive non-ferrous machining.

This cutter suits machinists working with abrasive non-ferrous materials such as graphite, composites or high-silicon aluminium where polycrystalline diamond retains its edge. It is not for ferrous alloys because the diamond reacts chemically with iron at cutting temperatures.

5/8 inch diameter, 2-flute PCD ball geometry

The 5/8 inch diameter and two-flute ball geometry set the radial engagement and chip clearance for each pass. Match these dimensions to your holder and toolpath requirements to confirm fit before ordering.

How it compares

Measured against everything we stock in Bits, Hole Saws & Accessory Kits, at today’s prices. Recalculated every night.

Price $601.99
Pricier than about 92% of the 5,493 comparable items (median $27.99).

Specifications

Product
Brand nameM.A. FORD

Questions about this item

What pneumatic tool holder or collet do I need to run the DE2B6250 ball end mill?

The cutter has a 5/8 shank, so it fits a standard 5/8 collet or tool holder used with your pneumatic router or spindle.

Will the two-flute design work with my older pneumatic router running at lower RPM?

Two-flute geometry is tolerant of moderate speeds; match the feed to the machine's capability and watch for chatter.

How can I confirm the DE2B6250 is cutting correctly after installation?

Listen for a steady, even tone and check that the finished radius shows smooth, consistent material removal without burning.

More in Bits, Hole Saws & Accessory Kits

Similar items