We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Cylindrical silver end mill with rounded tip and two spiral flutes

M.A. Ford

M.A. Ford Tuffcut GP 2 Flute Ball Nose End Mill 7/64 15010930

SKU CH-SWMV-KQ89S

A 7/64 inch two-flute ball-nose end mill for contour milling in general-purpose applications

  • Two-flute ball nose cuts smooth contours
  • 7/64 inch diameter suits fine detail work
  • M.A. Ford TuffCut GP built for general purpose milling
  • New condition guarantees full cutting performance
  • California Proposition 65 warning informs safe handling

M.A. Ford 2-flute ball nose end mill

The M.A. Ford Tuffcut GP is a new solid-carbide end mill with two flutes and a ball nose profile. It is suited for general-purpose milling in a range of ferrous and non-ferrous materials where a radiused corner or full-radius contour is required.

7/64-inch diameter for standard tool holders

The 7/64-inch cutting diameter fits directly into collets or end-mill holders sized for that shank, allowing quick changes on CNC mills or manual machines. The two-flute geometry provides generous chip space for efficient evacuation in slotting and pocketing operations.

California Proposition 65 chemical warning applies

This product carries a Proposition 65 notice for substances identified by the State of California as causing cancer and reproductive harm. Buyers who must avoid listed chemicals entirely should select an alternative tool without such a warning.

How it compares

Measured against everything we stock in Bits, Hole Saws & Accessory Kits, at today’s prices. Recalculated every night.

Price $17.99
Cheaper than about 68% of the 5,493 comparable items (median $27.99).

Specifications

Product
Brand nameM.A. FORD

Questions about this item

What shank diameter does the 7/64 ball nose end mill need for a standard collet?

The 7/64 cutting diameter matches a 7/64 shank, so use a collet or chuck that grips 7/64 inches precisely.

What tool holder style fits the TuffCut GP 15010930 in a CNC milling spindle?

It fits any ER collet, Weldon flat holder or shrink-fit chuck that accepts a 7/64 inch shank.

Which installation step is most often missed when seating this 2-flute end mill?

Fully seat the shank to the holder's back stop before tightening; a gap causes run-out and premature wear.

More in Bits, Hole Saws & Accessory Kits

Similar items