We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Slender silver micro drill bit with coolant hole 10X 2.35 mm

M.A. Ford

M.A. Ford Twister Coolant 10X Micro Drill 2.35 mm

SKU CH-Z2TE-VS3N1

A 2.35 mm micro drill with 10x coolant-through capability for deep-hole precision

  • 10× reach drills deeper holes in one pass
  • 35 mm diameter suits precision micro-drilling tasks
  • Coolant-through design clears chips and reduces heat
  • California Prop 65 warning flags cancer-risk chemical
  • California Prop 65 warning flags reproductive-risk chemical

Twister Coolant 10X Micro Drill

The M.A. Ford Twister Coolant 10X Micro Drill is a precision cutting tool designed for machinists and toolmakers who require accurate small-diameter holes. It features integrated coolant delivery to improve chip evacuation and extend tool life during demanding operations.

Capacity and headroom

The 2.35 mm diameter suits micro-drilling tasks in metals and alloys where coolant access is critical. The 10X length-to-diameter ratio provides deep-hole capability, though chip packing may limit performance in extremely deep or abrasive materials.

California Proposition 65 notice

This product contains a chemical known to the State of California to cause cancer and birth defects or other reproductive harm. Users should review safety data sheets and follow handling precautions required by regulation.

How it compares

Measured against everything we stock in Bits, Hole Saws & Accessory Kits, at today’s prices. Recalculated every night.

Price $133.99
Pricier than about 89% of the 5,493 comparable items (median $27.99).

Specifications

Product
Brand nameM.A. FORD

Questions about this item

Will the 2.35 mm shank fit the collet on my older micro drill press?

The drill has a 2.35 mm shank; match it to your collet or chuck size before use.

How can I verify the Twister Coolant 10X is cutting correctly after installation?

Check for steady coolant flow through the internal channels and consistent chip evacuation at the 10X depth.

Does the package include any collets, holders or coolant fittings, or must I buy them separately?

Only the micro drill is supplied; collets, tool holders and coolant connections are sold separately.

More in Bits, Hole Saws & Accessory Kits

Similar items