We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Small silver twist drill bit 1.75 mm diameter

M.A. Ford

M.A. Ford Twister Micro-Tuff Drill 1.75 mm

SKU CH-QVAS-8R2HK

A 1.75 mm Twister Micro-Tuff drill bit built for precision drilling in tough materials

  • Precision drilling with 1.75 mm diameter
  • Twister Micro-Tuff design for clean holes
  • M.A. Ford industrial-grade manufacturing quality
  • Ships direct from manufacturer for authenticity
  • California Prop 65 chemical warning applies

Micro-Tuff Drill 1.75 mm

The M.A. Ford Twister Micro-Tuff Drill is a 1.75 mm cutting tool designed for precision drilling tasks. It is supplied new and targets machinists and technicians who require small-diameter holes in a variety of materials.

Suited for fine detail work

This drill suits operators producing small, accurate holes where a 1.75 mm diameter is specified. It is not intended for buyers who need larger diameters, higher material removal rates, or shank sizes that differ from the standard Micro-Tuff range.

Capacity limited to 1.75 mm

The tool comfortably handles its nominal 1.75 mm diameter in appropriate workpiece materials. It reaches its limit when hole sizes exceed this value or when applications demand coolant-through capability or specialised coatings not indicated for this model.

How it compares

Measured against everything we stock in Bits, Hole Saws & Accessory Kits, at today’s prices. Recalculated every night.

Price $12.99
Cheaper than about 82% of the 5,493 comparable items (median $27.99).

Specifications

Product
Brand nameM.A. FORD

Questions about this item

What chuck size do I need to hold the 1.75 mm shank?

A drill chuck that closes down to 1.75 mm or smaller will grip the shank; check your chuck's minimum capacity before use.

Can I run this drill in a standard 3/8 in cordless drill?

Yes, if the chuck can tighten fully on a 1.75 mm shank; many 3/8 in keyless chucks stop at a larger minimum, so verify the spec.

How do I confirm the bit is cutting correctly after I start drilling?

The drill should produce a steady, quiet cut with consistent chip formation and no wobble; vibration or squealing means the shank is not seated or the speed is wrong.

More in Bits, Hole Saws & Accessory Kits

Similar items