We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Solid carbide drill bit, 7.30 mm diameter, matte grey finish

M.A. Ford

M.A. Ford Twister Xd 5X Solid Carbide Drill 7.30Mm

SKU CH-WPFJ-7DMF6

A 7.30 mm solid carbide drill bit for high-performance drilling applications

  • 30 mm diameter fits precise drilling tasks
  • Twister Xd 5X geometry supports five-times-diameter depth
  • Solid carbide construction resists wear in tough materials
  • M.A. Ford brand signals professional-grade tooling
  • California Proposition 65 warning informs safe handling practice

M.A. Ford Twister Xd 5X Solid Carbide Drill

The M.A. Ford Twister Xd 5X is a solid carbide drill bit manufactured to a 7.30 mm diameter. It is designed for high-performance drilling in demanding industrial applications where tool rigidity and wear resistance are critical.

Suited for precision drilling in tough materials

This drill suits machinists and fabricators who require a rigid, long-lasting tool for producing accurate 7.30 mm holes in hardened alloys or abrasive composites. It is not intended for hand-held use in soft woods or plastics where a high-speed steel bit would be more appropriate and cost-effective.

7.30 mm cutting diameter

The 7.30 mm diameter is the primary specification that determines fit for a specific hole size or tap drill requirement. Verify this exact measurement against your engineering drawing or thread chart before ordering to ensure compatibility with the intended fastener or operation.

How it compares

Measured against everything we stock in Bits, Hole Saws & Accessory Kits, at today’s prices. Recalculated every night.

Price $114.99
Pricier than about 86% of the 5,493 comparable items (median $27.99).

Specifications

Product
Brand nameM.A. FORD

Questions about this item

What size collet or chuck is required to hold the 7.30 mm shank of this Twister Xd drill?

A 7.30 mm capacity collet or three-jaw chuck is needed; the drill shank matches that diameter exactly.

Can the 2XDSR2874A be used in a standard drill press alongside older high-speed steel bits?

Yes, it fits any machine with a 7.30 mm chuck, but run it at carbide-appropriate speeds and feed rates rather than HSS settings.

How can I confirm the 5X solid carbide drill is cutting correctly after installation?

Check for a straight, round 7.30 mm hole with consistent chip evacuation and no chatter marks at the recommended feed.

More in Bits, Hole Saws & Accessory Kits

Similar items