We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Solid carbide drill bit, 9.20 mm diameter, silver-grey finish

M.A. Ford

M.A. Ford Twister Xd 5X Solid Carbide Drill 9.20Mm 2XDSR3622A

SKU CH-D0GB-JNEZ3

A solid carbide drill bit with a 9.20 mm diameter for high-performance drilling applications

  • Solid-carbide construction resists wear for longer tool life
  • 5× diameter reach drills deeper holes in one pass
  • 20 mm diameter matches precise hole requirements
  • Twister XD geometry improves chip evacuation while cutting
  • California Proposition 65 warning discloses regulated chemical content

Solid carbide drill 9.20 mm

This 9.20 mm solid carbide drill is built for high-speed drilling in steel, stainless steel and cast iron. The Twister Xd 5X geometry keeps chips short and evacuation clean, so machinists and tool-room technicians can run deeper holes without pecking.

Five-times-diameter flute length

The flute length is five times the 9.20 mm diameter, giving a single-pass drilling depth that standard jobber drills cannot reach. Buyers who need longer reach or a different diameter will need another tool.

Straight-shank fit for standard holders

The plain cylindrical shank drops into any ER collet, hydraulic chuck or three-jaw holder without adapters. Problems arise when the holder run-out exceeds a few microns, as carbide will chip instead of deflecting.

How it compares

Measured against everything we stock in Bits, Hole Saws & Accessory Kits, at today’s prices. Recalculated every night.

Price $155.99
Pricier than about 90% of the 5,493 comparable items (median $27.99).

Specifications

Product
Brand nameM.A. FORD

Questions about this item

What hole depth can the 9.20 mm Twister Xd 5X drill reach in a single pass?

The five-times-diameter design allows drilling up to five times the 9.20 mm diameter in one pass, so the practical depth limit is set by that ratio and your machine travel.

What shank standard does the 2XDSR3622A use and what does it limit?

It uses a standard cylindrical shank that fits common drill chucks and collets; the shank diameter caps the maximum holder capacity you can use.

What physical clearance does the 9.20 mm solid carbide drill need to fit in my setup?

You need enough spindle travel for the full flute length plus shank engagement, and a holder that accepts the drill’s shank diameter without interference.

More in Bits, Hole Saws & Accessory Kits

Similar items