Maudlin Products 002-6-100 Shim Roll 302 Full Hard 6x100 In x 0.051mm hand tool

Precision Shim Stock for Corrosive Environments

This roll supplies 18-8 stainless steel shim stock in a full-hard temper for alignment and spacing tasks. The material meets AMS-5906 and ASTM-A-666 standards for consistent quality. It is suited for maintenance crews in oil refineries and desalination plants where corrosion resistance is critical. The silver finish identifies the plain, uncoated surface.

Dimensional Tolerances Define Fit

Thickness is held to +/- 0.0001 in, width to +/- 0.005 in, and length to +/- 0.250 in. These tolerances determine whether the shim can close a specific gap without forcing or loosening over time. The 0.002 in nominal thickness provides a fine adjustment increment. Builders needing tighter or looser control must verify these limits against their assembly requirements.

0.002 Inch Thickness Governs Selection

The single specification that decides suitability is the 0.002 in nominal thickness with its 0.0001 in tolerance. If the design gap calls for a different step size, this roll cannot be used. The 6 in width and 100 in length only affect how many pieces you can cut. Buyers who need a different thickness must source another grade.