Maudlin Products slotted shim 4 in 0.050 in pack of 10

Precision alignment shims for machinery setup

This pack contains ten tabbed stainless-steel shims designed for accurate spacing and alignment tasks. Each piece measures four inches square with a nominal thickness of 0.050 in. The soft annealed 18-8 grade material allows easy handling and trimming on site. They suit maintenance technicians and millwrights who need repeatable shim stacks.

Slotted tabs simplify bolt-on installation

A 1 1/4 in wide slot runs 2 3/4 in deep, while a 3/4 in high tab extends 2 1/4 in wide for positive location on anchor bolts or studs. The plain finish resists corrosion without added coatings that could affect tolerance. Tight thickness tolerance of ±0.001 in and length or width tolerance of ±0.015 in keep stacks predictable during reassembly.

Thickness 0.050 in decides the stack height

The single critical dimension is the 0.050 in nominal thickness with its ±0.001 in tolerance. If the gap you must close falls outside the range this shim provides, the part will not work regardless of material or slot geometry. Buyers needing finer or coarser increments should select a different thickness grade.