Maxxima MLS-1827BL Strip Light 18 in Blue
An 18 in blue LED strip light with self-adhesive mounting, IP68 rating, and 12.8V DC operation
- Blue LED glow adds style to any project
- IP68 rating protects against dust and water ingress
- 8V DC operation suits standard vehicle systems
- Self-adhesive backing enables quick surface mounting
- 100,000-hour lamp life delivers long-lasting illumination
18-Inch Blue LED Strip Light
The Maxxima MLS-1827BL is a flexible, surface-mount LED strip that emits blue light at 12.8V DC. It measures 18 inches long, 1/2 inch wide and 3/16 inch high with an IP68 rating. The unit draws 0.6 A and includes a mounting kit with wire strain relief for secure installation.
Replaces Fixed Incandescent or Neon Fixtures
Swapping to this LED strip is worthwhile when you need a low-profile, waterproof light source that can conform to flat or slightly curved surfaces. The 100,000-hour lamp life reduces replacement frequency in machine-shop, automotive or marine environments where vibration and moisture degrade traditional bulbs.
Verify 12.8V DC Supply and Blunt-Cut Wiring
Confirm your system provides a stable 12.8V DC source and that you can terminate the blunt-cut leads safely. The self-adhesive backing requires a clean, flat mounting surface, and the IP68 seal must remain intact after wiring. No dimming or colour-control circuitry is included.
How it compares
Measured against everything we stock in Workshop Hardware, Springs & Clamps, at today’s prices. Recalculated every night.
- Price $18.99
- Typical for this category: the median of 383 items is $17.99.
Specifications
| Product | |
|---|---|
| Brand name | MAXXIMA |
Questions about this item
What surface area does the 18 in by 1/2 in adhesive cover?
The self-adhesive backing covers the full 18 in length and 1/2 in width of the strip, allowing direct surface mounting without extra brackets.
How are the blunt-cut leads connected to a 12.8V DC supply?
Strip the lead ends, match polarity to the 12.8V DC source, and secure with solder or crimp connectors; the built-in wire strain relief protects the joint.
When should the LED strip be replaced after 100,000 hr of use?
Plan replacement when light output drops noticeably; the rated 100,000 hr lamp life assumes continuous operation at the specified 0.6 A current.
More in Workshop Hardware, Springs & Clamps
Similar items
Craftsman CMMT16061 Deep Impact Socket 1/2-Inch Drive 3/4-Inch
- Out-Opening, Narrow…
- Steel
De-Sta-Co 5105-R Vertical Hold-Down Clamp 700 lb Machine Shop Hardware
Carbyne 3-Piece Impact Socket Adapter Set 1/4 3/8 1/2 Drive 3 in. Spring-Loaded Ball Lock
- 0.25 in (0.64 cm)
- On product combined…
Renewable Lubricants Parts Cleaner Degreaser 5 gal Pail 86634 machine shop hardware
- HAWA
Amartisan AM020 20-Piece Hex Bit Set S2 Steel 2.3" Machine Shop Hardware
- 20-Piece Hex Bit Se…
- Steel





