Micro 100 CRE-312-125X Corner Rounding End Mill .1200 Carbide 3 Flute

Micro 100 CRE-312-125X corner rounding end mill

This carbide tool is built for machinists who need to break sharp edges with a consistent radius. The three-flute geometry and AlTiN coating support clean finishes in steel, stainless steel and other ferrous alloys. It suits both manual and CNC milling operations where a precise corner profile is required.

0.1200 inch radius with three-flute carbide

The cutter produces a 0.1200 inch corner radius in a single pass. Three flutes balance chip evacuation and surface finish while the solid carbide body resists wear at higher cutting speeds. AlTiN coating further reduces friction and extends tool life in demanding materials.

Runs cool with light cuts in typical milling

Carbide construction and the AlTiN layer keep temperatures low during normal profiling passes. Three flutes generate less vibration than two-flute alternatives, so noise stays moderate on rigid setups. Power draw remains modest when feeds and speeds follow standard carbide recommendations.