Micro 100 RNCM-030-1X Engraving Tool 5.00 mm 90 Degrees Carbide AlTiN

Engraving Tool 5.00 mm 90 Degrees

Micro 100 RNCM-030-1X is a single carbide engraving tool with a 5.00 mm length of cut and a 90 degree angle. It is built for precision marking and engraving tasks in professional workshops. The AlTiN coating supports wear resistance during repeated use.

Sustained Engraving Performance

Carbide construction and AlTiN coating maintain cutting geometry under continuous load rather than only in short passes. The tool resists heat buildup and edge degradation during extended engraving cycles. Consistent material removal is achieved without frequent tool changes.

Metric Standard Practical Limits

The 5.00 mm length of cut defines the maximum depth reachable in a single pass within the metric standard. The 90 degree included angle limits the profile to V shaped grooves of that geometry. Users needing different depths or angles must select alternative tooling.