We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Micro 100 carbide engraving tool, 60 degree tip, uncoated finish

Micro 100

Micro 100 RSC-250-2 Engraving Tool 60 Degrees Carbide .004 in 1/2 in

SKU CH-BEMB-GNVMJ

Carbide engraving tool with a 60-degree double tip and .004-inch width

  • Product typeHole, Drill, Bore & Wire Gauges
  • Main materialCarbide
  • Product weight0.05
  • Carbide construction resists wear for long tool life
  • 60-degree angle creates precise V-groove engravings
  • .004-inch tip width produces fine detail lines
  • 1/2-inch shank fits standard tool holders
  • Lightweight 0.05 lb design reduces operator fatigue

Micro 100 Engraving Tool for Precision Work

This carbide engraving tool features a 60 degree double tip and a .004 inch point for fine detail. It suits machinists, hobbyists and technicians who need accurate marking or light cutting on metal surfaces.

Replaces Worn Single Point Engravers

The double ended design gives two fresh cutting edges before replacement is needed. Upgrading makes sense when a single point tool dulls quickly or when a 60 degree included angle matches the required mark geometry.

Verify Holder Compatibility Before Ordering

The tool has a 1/2 inch shank diameter so your tool holder or collet must accept that size. Confirm the machine spindle can run the small diameter carbide without excessive runout. Carbide is brittle and requires rigid setup.

How it compares

Measured against everything we stock in Utility & Specialty Hand Tools, at today’s prices. Recalculated every night.

Price $42.99
Pricier than about 70% of the 2,474 comparable items (median $23.99).

Specifications

Product
Brand nameMicro 100
Product typeHole, Drill, Bore & Wire Gauges
Size & build
Main materialCarbide

Questions about this item

What shank diameter does the 1/2 in Micro 100 RSC-250-2 engraving tool require?

The tool has a 1/2 in shank, so it fits holders or collets sized for that diameter.

How is the double-ended 60 degree carbide engraver secured, and what mistake should be avoided?

Clamp the 1/2 in shank evenly in a collet or holder; do not over-tighten one side, which can crack the carbide tips.

When will the .004 in tip width on this carbide engraving tool need replacement?

Replace the tool when the .004 in cutting edges show visible wear or produce rough lines in the workpiece.

More in Utility & Specialty Hand Tools

Similar items