Micro 100 RSC-375-2 Engraving Tool 60° 1/2" Carbide

Micro 100 Engraving Tool 60° Carbide

The Micro 100 RSC-375-2 is a double-ended engraving tool ground to a 60 degree included angle. It is manufactured from uncoated carbide and accepts a 1/2 inch length of cut with a .0040 inch tip radius. This accessory is intended for precision marking and engraving tasks on compatible power or pneumatic equipment.

Machinists needing a sharp 60 degree point

The 60 degree geometry suits operators cutting clean V-grooves, lettering or decorative lines in metals and plastics. Users requiring a different included angle, a coated substrate for abrasive materials, or a larger tip radius for heavier chip loads should select an alternative tool specification.

Uncoated carbide substrate ships ready to use

The tool arrives without a coating, so it can be sharpened or re-ground in-house to maintain the original 60 degree profile. No additional accessories, holders or software are bundled; the operator supplies the appropriate collet or tool holder for the machine spindle.