Middle Atlantic HG 10-32 Truss Head Phillips Rack Screws 0.75in Black Gloss 100 Pack

Middle Atlantic HG Rack Screws 100 Pack

These steel fasteners use a 10-32 thread and a 0.75in truss head with a Phillips drive. The black gloss finish resists salt spray and suits marine or high-humidity installations. Each screw ships with a factory-installed nylon washer and a self-guiding pilot point for quick alignment. The pack contains 100 pieces for standard rack-mount builds.

Thermals Noise and Power

As passive metal fasteners these screws generate no heat, produce no audible noise and draw no electrical power. The steel construction and salt-spray-resistant plating maintain holding strength in damp environments without degradation. Pre-installed nylon washers distribute load evenly and protect rack surfaces during tightening. No active cooling or power budget is required.

Thread Pitch 10-32 Decides Fit

The 10-32 thread pattern determines whether these screws match your equipment rails; verify the rail specification before purchase. Builders needing a different thread count or a longer shaft must select another fastener. The truss head sits low enough to clear optional trim strips for a flush finish. Only the thread pitch confirms compatibility.