Movo SR-UM10-CC1 dual-XLR output connector cable camera accessory

Dual-XLR output for Saramonic wireless systems

This cable connects Saramonic LavMic, UwMic9, UwMic10 and UwMic15 wireless microphone receivers to camcorders or interfaces equipped with dual-XLR inputs. A locking 3.5 mm TRS plug secures the link to the receiver, preventing accidental disconnection during recording. Gold-plated contacts maintain clean signal transfer across the connection. The assembly splits the receiver output into two mono XLR feeds for separate channel recording.

Locking connector holds under continuous movement

The threaded 3.5 mm plug resists vibration and cable tugs that would loosen a standard connector during extended shoots. Shielded construction protects the audio path from electromagnetic interference when the cable runs alongside power leads or lighting gear. Gold plating reduces contact oxidation that can degrade signal quality over repeated mating cycles. The Y-split geometry keeps both XLR tails tidy on a mixer or camera handle without strain on the receiver port.

Dual-XLR input splits one receiver into two mono

Each 3-pin XLR carries the same mono signal, allowing a mixer or recorder to treat the wireless feed as two independent channels for gain staging or redundancy. This wiring scheme works only with devices that accept dual-XLR inputs; cameras or recorders with a single XLR or a stereo mini-jack cannot use the split without an additional adapter. The cable passes analogue audio only and does not convey digital metadata or remote-control signals.