NEMIX RAM 32GB DDR5 4800 ECC Unbuffered UDIMM 2Rx8 CL40 1.1V 288-Pin server RAM
- 32 GB
- 288-Pin DDR5 ECC UD…
We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.
32 GB DDR5-5200 ECC UDIMM with CL42 latency, 2Rx8 organisation and 1.1 V operation for server workloads
This single 32 GB DDR5 5200 module delivers error-correcting code memory for platforms that require data integrity. It targets IT professionals upgrading enterprise servers, workstations or NAS devices where ECC unbuffered DIMMs are specified. The 2Rx8 organisation suits high-capacity configurations on compatible motherboards.
The bare green PCB fits standard 288-pin DDR5 slots without extra height clearance concerns. Unbuffered signalling keeps latency low for supported consumer and entry-level server chipsets. Major OEM DRAM from Samsung, Micron or Hynix is used depending on supply, and every module is stress-tested under load before shipment.
Rated at DDR5 5200 (PC5-41600) with CAS latency 42, this module runs at the baseline JEDEC voltage of 1.1 V. Builders needing tighter timings, higher frequencies or registered DIMMs must select a different part.
Measured against everything we stock in ECC Server RAM, at today’s prices. Recalculated every night.
New to this? Buying memory and SSDs with crypto — what to check, what it costs to pay, and what is never asked for.
| Product | |
|---|---|
| Brand name | NEMIX RAM |
| Product line | NEMIX RAM Original Series Memory |
| Model name | DDR5 ECC Unbuffered UDIMM Memory |
| Part number | ME41600-328K1 |
| Total capacity | 32 GB |
| Product type | 288-Pin DDR5 ECC UDIMM |
| Performance | |
| Rated speed | DDR5 5200 (PC5 41600) |
| Processor | |
| Chipset | Major OEM Samsung, Micron, Hynix |
| Memory | |
| CAS latency | CL42 |
| ECC support | Yes |
| Buffer type | Unbuffered |
| Memory rank | 2Rx8 |
| Heat spreader | No |
| Power | |
| Rated voltage | 1.1 V |
Other versions of this model
It operates at DDR5 5200 with a PC5-41600 data rate, so the memory controller will cap transfers at that 5200 MT/s ceiling unless the platform forces a lower JEDEC bin.
The stick uses a standard 288-pin DDR5 UDIMM edge connector and fits any desktop or workstation board with an unbuffered DDR5 DIMM slot; no heat spreader means low-profile coolers clear it easily.
Power down, open the retention clips, align the off-centre key notch with the slot, press firmly until both clips snap shut, then enable ECC in the BIOS — skipping that BIOS toggle leaves error correction inactive.
More in ECC Server RAM
What you pay in, and what you read prices in.
Sent from your wallet at checkout
Display only — the catalogue is priced in USD
No currency matches that.
New here?
Already have one?
There is no automatic reset: this shop sends no mail, so there is no one-time link to ask for. Leave the address on the account and it gets picked up by hand.
Request noted
Nothing is on its way to your inbox — this shop sends no mail at all. Someone picks these up by hand.
Remembered it?