No Sew USB 2.0 B male-to-female extension cable 0.5 m right-angle screw-mount

USB 2.0 Type B extension for tight installs

This 0.5 m cable adds reach between a host and any USB 2.0 Type B peripheral such as a printer, scanner or industrial controller. The right-angle male plug routes the cable flat against the device so it fits behind equipment or inside shallow enclosures. A screw-mount bracket on the female end lets installers secure the port to a wall plate or panel for a permanent, tidy connection. It suits AV integrators, factory-floor technicians and office users who need a fixed access point.

Passive copper link draws no extra power

The cable uses copper conductors and carries only the bus power the host already supplies, so it adds no thermal load and runs silently. Backward compatible with USB 1.1 at 12 Mbps and USB 1.0 at 1.5 Mbps, it negotiates the highest speed both ends support up to 480 Mbps. No driver or external supply is required; the link behaves like a direct connection once plugged in.

Panel-mount female end frees the device port

Locking the female connector to a wall plate or panel moves the mating point away from the peripheral, protecting its native port from repeated plug cycles. The 90-degree male plug keeps the short tail close to the device chassis, reducing strain on the socket and leaving adjacent ports unobstructed. Installers gain a clean, fixed USB B outlet without modifying the connected hardware.