NOYITO Alligator Clip to USB Male Test Cable 3.2ft Pack of 2

Test Cable for Low-Voltage Work

This pair of NOYITO cables mates a standard USB Type A male plug with red and black alligator clips for quick low-voltage testing. Each lead measures 3.2 ft overall, giving enough reach for bench work without excess slack. The copper conductors are terminated at one end by a USB-A connector and at the other by insulated crocodile clips. Two cables are included so power and ground can be connected simultaneously.

Copper Build and Clip Convenience

Solid copper wire runs the full .92 metre span between the USB housing and the clips, keeping resistance low for modest current tasks. The red and black colour code makes polarity identification instant, reducing the chance of a reversed connection. The alligator jaws open wide enough for component leads, screw terminals or board test points, then grip firmly without special tools. The USB-A plug fits any standard host port, so no proprietary adapter is required.

Replaces Improvised Leads and Soldered Tails

These cables remove the need to solder temporary wires onto a USB plug or to jury-rig clip leads with tape and heat-shrink. The jump is worth it whenever a repeatable, insulated connection to a USB power source is needed — firmware flashing, sensor biasing or quick continuity checks. They are not suited for high-current charging, data-line access or any application that demands a locking connector or shielded data pairs.