Projector Ceiling Mounts Direct, LLC. OPTOMA-H116ST projector accessory

CNC-machined aluminium projector mount

This ceiling mount is built from CNC-machined 6061-T6 aircraft-grade aluminium for a precise fit on specific Optoma projectors. It positions the unit roughly 4 inches from the ceiling and provides full 360-degree rotation with +/- 35-degree pitch and roll adjustment. All mounting hardware and detailed instructions are included for installation on drywall or wooden beams.

For Optoma short-throw owners needing a fixed offset

The mount suits installers fitting an Optoma H116ST, HD29H, W308STe, W318ST, X308STe or X318ST where a permanent 4-inch ceiling drop is acceptable. It is not intended for drop or false ceilings, and the plate will not fit any projector model outside the listed series. Buyers needing variable extension length or universal compatibility should look elsewhere.

Stable orientation under continuous use

The rigid aluminium plate and fixed 4-inch standoff keep the projector steady during long operating sessions without sag or drift. Heat can escape freely around the minimal-coverage plate, so thermal performance remains consistent over extended periods. The 360-degree swivel and +/- 35-degree tilt range stay firmly locked once tightened, even after repeated thermal cycles.