Pyramid Car Audio TW1193A 2" 100W Peak Tweeter Speaker

Compact 2-inch piezo tweeter for car audio upgrades

The Pyramid TW1193A is a surface-mount tweeter built around a 2" Motorola piezo driver. It targets installers adding high-frequency detail to a factory or aftermarket system without cutting large holes. The shallow 0.75" mounting depth fits tight door panels or dash locations where deeper drivers will not sit. Buyers needing mid-bass output or a full-range single-driver solution should look elsewhere.

100 W peak and 50 W RMS power handling

At 50 W RMS the tweeter handles typical amplifier channels cleanly; 100 W peak gives short-term headroom for dynamic passages. The 88 dB sensitivity means it reaches listening level with modest power, but it will not keep pace with high-output component sets driven by 100 W per channel or more. The 5 kHz to 30 kHz response covers the upper octaves; content below 5 kHz rolls off, so a separate midrange or woofer is required.

Piezo driver requires no crossover but lacks

The piezo motor operates directly from the amplifier without a passive network, simplifying wiring and saving space. Because there is no built-in high-pass filter, frequencies below 5 kHz reach the diaphragm and can cause distortion or damage at high drive levels. Installers must add an external capacitor or active crossover set above 5 kHz. The included mounting hardware and wires speed up a basic installation.