APC APCRBC158 UPS Replacement Battery for BX1000M
- Battery
- APCRBC158, APC
We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.
A compatible replacement battery kit containing one 12V 9A sealed lead-acid unit for APC RBC17 UPS models
This kit provides a direct replacement cartridge for APC UPS models that use the RBC17 battery pack. It contains one sealed lead-acid battery rated at 12 volts and 9 ampere-hours. The unit arrives factory fresh and includes comprehensive installation instructions. It is intended for administrators maintaining existing APC UPS hardware.
The sealed lead-acid chemistry operates silently with no moving parts during normal float charging or discharge. Heat output is minimal under typical standby loads found in server rooms or wiring closets. The battery draws only the low float current required to maintain full charge. No active cooling or special ventilation is required beyond standard UPS enclosure airflow.
The cartridge fits the existing battery compartment without modification and reuses the original wiring harness. Installation requires only basic hand tools and adherence to the included safety steps. The kit restores runtime for critical loads connected to the UPS. It does not add extra capacity beyond the original specification or support hot-swap replacement on models lacking that feature.
Measured against everything we stock in UPS Replacement Batteries, at today’s prices. Recalculated every night.
New to this? Which coin should you pay with — what to check, what it costs to pay, and what is never asked for.
| Product | |
|---|---|
| Brand name | APC |
| Product line | APC |
| Product type | Kit/Package |
Power off and unplug the UPS, remove the front panel, disconnect the old battery leads noting polarity, connect the new 12V9A battery with the same polarity, reassemble the panel, then power on and allow the UPS to charge fully before putting it back into service.
The sealed lead‑acid battery typically lasts three to five years; plan to replace the whole cartridge when runtime drops noticeably or the UPS signals a battery fault.
The 9 Ah capacity determines total runtime; under sustained load the battery will deplete before any thermal or electronic limit is reached.
More in UPS Replacement Batteries
What you pay in, and what you read prices in.
Sent from your wallet at checkout
Display only — the catalogue is priced in USD
No currency matches that.
New here?
Already have one?
There is no automatic reset: this shop sends no mail, so there is no one-time link to ask for. Leave the address on the account and it gets picked up by hand.
Request noted
Nothing is on its way to your inbox — this shop sends no mail at all. Someone picks these up by hand.
Remembered it?