Rifachua 4 Pin 10mm LED Strip Connectors 22 AWG RGB Extension Wire

10 mm 4-pin RGB connector kit

The kit provides solderless connectors and 16.4 ft of 22 AWG extension wire for 10 mm RGB LED strips. It suits installers who need a quick, reusable way to join or extend 3528 or 5050 strips at 5 V, 12 V or 24 V. The connectors accept both solid and stranded 22 AWG conductors without stripping. Builders using 8 mm strips or 20 AWG wire must look elsewhere.

16.4 ft 22 AWG wire with 300 V rating

The oxygen-free tinned copper cable is rated for 300 V and 100 W at 1 A, giving headroom for typical low-voltage RGB runs. PVC insulation remains flexible from -30 to 80 °C, so the wire handles engine-bay heat or cold-weather installs. Runs exceeding 1 A or needing heavier gauge will require a different cable.

Flame-retardant housing with dual copper sheets

Each connector uses a two-layer copper sheet that clamps the strip between the layers for a secure, vibration-resistant joint. The wire end uses blade contacts that bite into inserted conductors when crimped with pliers, eliminating solder and stripping. Housings are reusable; a pocket knife can release the latch for changes. Silicone coating on strip pads must be removed before insertion.