We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in

Road Power

Road Power SS68-4 Battery Cable 4AWG 68in Black

SKU CH-KMXZ-DMNHH

4 AWG battery cable with lugs carries 400 A at 12 V over 68 inches and resists water, grease, sunlight and abrasion

  • Product typeBattery, Switch To Starter
  • 400 A maximum current powers heavy-duty starts
  • 68 in length reaches across engine bays
  • 4 AWG copper conductor handles high amperage
  • PVC insulation resists water grease sunlight abrasion
  • 12 V rating suits standard automotive systems

Automotive battery cable 4 AWG

This 68 in black cable connects a battery to a starter using flattened copper lugs. It is built for 12 V systems and rated for up to 400 A. The PVC insulation resists water, grease, sunlight and abrasion. It meets RoHS and SAE SGT standards.

Replaces worn or undersized starter leads

Swapping out corroded or thinner gauge wire restores full cranking current to the starter motor. The 4 AWG conductor reduces voltage drop compared to smaller cables. The jump is worth it when slow cranking or heat at the terminals signals excessive resistance.

Sustained load performance

Copper lugs and PVC jacketing maintain conductivity at up to 140 Degrees F. Resistance properties protect against degradation from engine bay contaminants. The cable handles continuous high-current demands during repeated starting cycles without overheating.

How it compares

Measured against everything we stock in Wire, Cable & Wiring Supplies, at today’s prices. Recalculated every night.

Price $19.99
Cheaper than about 58% of the 1,610 comparable items (median $25.99).

Specifications

Product
Brand nameRoad Power
Product typeBattery, Switch To Starter

Questions about this item

What stud size does the flattened lug on this 68 in cable fit?

The flattened lug is designed for a 5/16 in stud size to connect the switch-to-starter circuit.

How do you install the pre-crimped lugs on this 4 AWG battery cable, and what step is often missed?

Route the 68 in cable, bolt each lug to its terminal, then tighten to spec; the step often missed is cleaning the terminal faces before tightening.

When should this PVC-insulated 4 AWG cable be replaced based on its 140 °F temperature rating and resistance properties?

Replace it if the insulation shows cracking, grease swelling, or heat damage beyond the 140 °F rating, or if water and abrasion resistance are compromised.

More in Wire, Cable & Wiring Supplies

Similar items