We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Robertshaw 41-803 hot surface igniter flat round tip 15 1/2 in lead 120V

Robertshaw

Robertshaw 41-803 Hot Surface Igniter 120V 15 1/2 in lead

SKU CH-BVXR-BKJKQ

Silicon-nitride hot-surface igniter with 15 1/2 in leads for 120 V AC furnaces, rated to 392 °F insulation temperature

  • Product typeLearning Thermostats
  • Silicon nitride element resists thermal shock up to 392 °F
  • 15 1/2 in leads fit existing furnace wiring without splicing
  • Flat-round tip matches OEM probe geometry for direct replacement
  • 120 V AC rating suits standard residential heating systems
  • Learning thermostat platform adapts to system cycles for reliable ignition

Hot Surface Igniter 41-803

The Robertshaw 41-803 is a 120V AC hot surface igniter built for gas-fired heating equipment. It uses a silicon nitride heating element that reaches ignition temperature quickly and resists thermal shock. The flat round tip and 15 1/2 in hardwired leads allow direct mounting in many OEM furnace and boiler designs. It serves as a direct OEM replacement part for compatible heating systems.

OEM replacement for worn igniters

This igniter replaces original equipment units that have cracked or developed high resistance after repeated heating cycles. Silicon nitride construction lasts longer than older silicon carbide designs under the same 120V supply. The upgrade is worth it when the existing igniter shows visible damage or causes delayed ignition faults. The 392 Degrees F lead insulation rating suits standard furnace compartments.

Hardwired 15 1/2 in leads for direct fit

The 15 1/2 in lead length and hardwired connection let the part install without adapters or splices in matched OEM brackets. A 2 in probe positions the flat round tip in the burner flame path for reliable ignition. Installers must verify the original mounting geometry and voltage match before fitting. The component frees up no additional space and requires no control-board changes.

How it compares

Measured against everything we stock in Thermostats & Thermostat Accessories, at today’s prices. Recalculated every night.

Price $19.99
Cheaper than about 85% of the 286 comparable items (median $78.49).

Specifications

Product
Brand nameROBERTSHAW
Product typeLearning Thermostats

Questions about this item

Will the 15 1/2 in lead reach my furnace terminal block?

The 15 1/2 in lead provides enough length for most standard furnace terminal blocks; measure your existing igniter lead to confirm.

How do I install this hardwired 120V AC igniter without damaging the silicon nitride element?

Turn off power, disconnect the old igniter, connect the new leads with wire nuts, and avoid touching the silicon nitride probe with bare hands.

When should I replace this igniter if the 392 degree F insulation rating is exceeded?

Replace the igniter if the lead insulation shows cracking, discolouration, or if the furnace fails to light after the igniter glows.

More in Thermostats & Thermostat Accessories

Similar items