Slugger By Fein 63127624110 carbide annular cutter 1-3/8 x 3 in

Slugger By Fein 63127624110 carbide annular cutter

This annular cutter is built for magnetic-base drills and other machines that accept a 3/4 in Weldon flat shank. It is suited for fabricators and maintenance crews cutting structural steel, plate or pipe where a solid carbide tooth geometry extends tool life in abrasive or hardened materials. The 1-3/8 in diameter produces a clean slug rather than a full chip load, reducing horsepower demand on the drive unit.

Carbide teeth and bright finish

The carbide tips resist heat and wear far longer than high-speed steel when cutting tough alloys or layered plate. The bright, uncoated surface avoids coating delamination in high-heat cuts and allows easy resharpening on standard equipment. A 3 in maximum cutting depth lets the tool reach through thick flanges or double plates in a single pass, eliminating the need for step drilling or multiple tool changes.

Weldon flat shank installation

The 3/4 in Weldon flat seats directly into standard magnetic-drill arbors with a set-screw lock, so no adapter sleeves are required. Ensure the set screw engages the flat securely; a loose screw lets the cutter walk and damages both the shank and the workpiece. Verify that the machine spindle runs true — excessive run-out chips the carbide tips within the first few seconds of the cut.