SXDOOL efh-08e12w-ip01 80mm case fan 8025 12V 0.70a 4-pin PWM

Compact 80mm PWM case fan

The SXDOOL efh-08e12w-ip01 is an 80mm square frame fan designed for tight chassis locations where a larger rotor cannot fit. Its four-pin PWM connector allows the motherboard to regulate speed automatically based on temperature sensors. The hydraulic bearing and black non-LED finish suit both office workstations and quiet home builds. Builders needing a slim 25mm profile for side-panel or GPU-bracket mounting will find the dimensions compatible.

Fits 80mm mounts with short 8.8cm lead

The fan screws into any standard 80mm mounting pattern and draws 0.70a from a 12V header, so a single motherboard fan header can drive it without a splitter. The 8.8cm cable reaches nearby headers on ITX or micro-ATX boards but may require an extension cable for bottom-mounted power supplies or full-tower rear exhaust positions. Four-wire control frees up BIOS fan curves for silent idle and targeted airflow under load. Installers without a spare 4-pin header cannot use PWM regulation.

Hydraulic bearing rated for 60000 hours

Speed ranges from 800 to 4500 rpm with a ±5% tolerance, delivering a wide operating window for sustained thermal loads. The hydraulic bearing is rated for 60000 hours of continuous operation, reducing the likelihood of bearing noise during long rendering or compile sessions. PWM speed measurement lets the board react to gradual temperature rises rather than relying on fixed voltage steps. Systems that demand constant maximum airflow at 4999 rpm will exceed this fan’s top speed.