We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Small black 47mm graphics card cooling fan with four-pin connector

SXDOOL

SXDOOL PLD05010S12H 47mm 12V 4-pin graphics card fan accessory

SKU CH-J5RN-CMFRA

A 47 mm, 12 V, 4-pin replacement fan with 39 mm mounting holes for legacy GeForce 8500 GT, 8600 GT, 9400 GT, 9500 GT and GT 210 graphics cards

  • 47 mm diameter fits tight GPU clearances
  • 39 mm hole spacing matches listed card models
  • 12 V 4-pin PWM header enables speed control
  • Direct replacement for 8500GT 8600GT 9400GT 9500GT GT210 coolers
  • New condition ensures full factory performance

Compatible GPU models

This 47 mm replacement fan fits NVIDIA GeForce 8500 GT, 8600 GT, 9400 GT, 9500 GT and GT 210 graphics cards. It restores active cooling on ageing boards that still serve basic display or light compute tasks.

Mounting and power interface

The unit uses a 39 mm hole spacing and a 4-wire 4-pin connector running at 12 V. Matching both dimensions and the pin layout is essential; a different pitch or 3-pin header will not align or report speed correctly.

Cooling capacity and limits

The compact 47 mm diameter suits the low-profile heatsinks found on the listed entry-level GPUs. It cannot move enough air for mid-range or high-end cards, and the fixed mounting holes prevent adaptation to larger coolers.

How it compares

Measured against everything we stock in Cable Locks & Laptop Extras, at today’s prices. Recalculated every night.

Price $17.99
Typical for this category: the median of 8,808 items is $16.99.

Specifications

No published specifications for this item yet.

Questions about this item

Will the 47 mm diameter and 39 mm screw spacing match the cooler on my 9500 GT?

The fan measures 47 mm across with mounting holes 39 mm apart, matching the original cooler on 8500 GT, 8600 GT, 9400 GT, 9500 GT and GT 210 cards.

How do I connect the 4-pin plug without damaging the header on the graphics card?

Align the keyed 4-pin connector with the card’s fan header, press straight down until it clicks, and route the cable so the blades cannot catch it.

When should I plan to replace the sleeve bearing in this 12 V fan?

Sleeve-bearing fans typically run quietly for two to three years of daily use; listen for rattling or speed drops and swap the unit when noise appears.

More in Cable Locks & Laptop Extras

Similar items