Systor SYS1011HS-DP 1-to-11 SATA Duplicator 90MB/s Dual Port Hot Swap

Standalone 1-to-11 SATA duplicator

The Systor SYS1011HS-DP copies one source drive to eleven targets at up to 90 MB/s without a host computer. It accepts 2.5-inch and 3.5-inch SATA hard drives or solid-state drives directly in its hot-swap slots. A 128 MB buffer and an LCD menu let you start, monitor and verify each operation from the front panel. The unit runs on 115 or 230 V mains power with a 400 W supply.

IT managers and data-centre teams needing fast.

Technicians who must duplicate operating-system images, forensic evidence or bulk deployment payloads across many drives will benefit from the simultaneous copy modes and DoD 5220.22-M compliant erase functions. The duplicator only works with drives that have a native SATA interface, so environments that rely on other drive protocols or form factors cannot use this hardware.

90 MB/s sustained copy throughput

The specified data transfer rate of 5.4 GB per minute (90 MB/s) is the single figure that determines whether the duplicator meets your production window. If your workflow demands higher sustained bandwidth, this model will not satisfy that requirement.