TAURKENAM 16-Pin OBDII Breakout Box Car Electronics Accessory

16-Pin OBDII Breakout Box for Diagnostics

This TAURKENAM accessory replicates the standard 16-pin OBDII layout so technicians can monitor communication, power and ground signals without back-probing. It accepts 4 mm banana plugs on every pin and includes four coloured jumper sets for wiring multiple test tools at once. The unit supports CAN bus, K-line, L-line and PWM protocol lines on both petrol and diesel vehicles. It is intended for professional engineers and advanced hobbyists who need simultaneous access to several diagnostic devices.

Installation and Common Issues

Connection is straightforward: plug the box between the vehicle OBDII port and the scanner, then attach banana leads or jumpers to the exposed pins. The coloured jumpers let you route signals to a recorder, navigation unit or programmer without splicing wires. The only caution in the supplier data is to avoid shorting the input jacks with jumpers while the box is disconnected from a vehicle, as this can damage the internal circuitry. No software installation or external power supply is required.

Compatibility Checks Before Ordering

Verify that the target vehicle uses a standard 16-pin OBDII connector and communicates over CAN, K-line, L-line or PWM protocols, as these are the only signal types the box is specified to detect. Confirm that your diagnostic scanner, recorder or programmer accepts 4 mm banana plugs or can be adapted to them. The accessory draws no separate power, so no battery or mains supply is needed, but ensure the vehicle ignition state matches the protocol you intend to monitor.