Teansic IC332-335 USB-A Male DIP Breakout Board 2.54mm 20Pcs

20-Piece USB-A Male Breakout Kit

This kit supplies twenty USB 2.0 Type-A male to DIP adapter boards for prototype and repair work. Each board breaks out the four standard lines VBUS, D+, D- and GND onto a 2.54 mm pitch header layout. The pack quantity suits hobbyists, students and small-batch builders who need multiple units on hand.

FR4 Board With 2.54 mm Hole Spacing

The boards are fabricated from FR4 laminate and measure within the 1.3 by 10.7 by 16.6 cm panel outline. Pins are not fitted; the 2.54 mm holes accept standard header pins or direct wire soldering. The panel arrives as a single piece that must be separated into individual modules before use.

Solder-Ready Modules For Custom Wiring

No headers or cables are included, so each builder chooses the pin style or wire gauge that matches the project. The boards handle up to 5 V and 2 A when fed from a USB power source, but they do not generate power themselves. Typical uses include breadboard power taps, 3D printer wiring and Bluetooth module interfaces.