Test Probes 4 Pack 2mm 600V/10A 0.2mm Needle 8.6cm Reach 3.7cm Grip

4-Pack 2 mm Needle Test Probes

This set supplies four extended needle probes — two red and two black — built for non-destructive circuit testing. Each probe carries a CAT II 600 V / 10 A rating and a 0.2 mm stainless steel needle tip that pierces insulation without cutting the conductor. The 8.6 cm reach lets technicians access deep harnesses while the 3.7 cm soft grip handle reduces fatigue during prolonged diagnostics. They connect to 4 mm banana sockets and fit 2 mm probe interfaces on common multimeter leads.

Automotive and marine technicians needing

The ultra-sharp 0.2 mm needle enables back-probing and wire-piercing measurements on sealed looms without compromising waterproofing. Users who require alligator clips, banana-to-banana leads or high-current shunt accessories will not find those functions in this kit. The probes are optimised for Fluke TL71 and TL75 style leads and compatible brands, so owners of proprietary connector systems should verify fit before purchase.

Push-fit banana connection installs in seconds

Simply insert the 4 mm banana plug into the multimeter lead and press the needle tip against the test point; the reverse-probing capability allows contact from either side of a connector. The most common issue is excessive sideways force snapping the 0.2 mm needle — apply only axial pressure and use the protective covers when the probes are stored. PVC shells and copper cores maintain stable readings up to the rated 600 V / 10 A.