Uei Test Instruments CP2 Flue Probe Assembly 10 ft for C160

Flue Probe Assembly 10 ft for C160

This flue probe assembly connects directly to the C160 combustion analyzer for sampling combustion gases. It is intended for HVAC technicians and combustion analysts who need to measure flue-gas composition in residential and light-commercial appliances. The 10 ft length provides reach into typical flue passages without excessive coil. The connector mates with the analyzer so the probe is ready to use on arrival.

Capacity and headroom: 10 ft reach

The 10 ft overall length lets the probe reach flue sampling ports on most standard furnaces, boilers and water heaters. It handles the temperature and moisture levels found in typical natural-gas and oil-fired equipment flues. Very deep or high-temperature industrial stacks may exceed the practical insertion depth or material limits of this assembly. Extremely tight bends or restricted access points can also limit effective use.

Included connector changes setup time

The probe ships with its mating connector already fitted, so no field termination or adapter hunting is required. Technicians can plug the assembly into the C160 and begin sampling immediately, reducing on-site preparation. The fixed connector means the cable cannot be shortened or repaired on the job if the plug is damaged. Users needing a different length or a replaceable connector will need a separate probe assembly.