Unique-Bargains 25W 18 Ohm Aluminium Chassis Mount Wirewound Resistors Green 5pcs
Pack of five 18 Ω 25 W wirewound resistors in aluminium chassis-mount housings for high-power heat dissipation
- 25 W power rating handles demanding circuits
- 18 Ω ±5 % tolerance for precise current control
- Aluminium chassis-mount housing dissipates heat efficiently
- 53 × 27 × 15.5 mm body fits tight enclosures
- Pack of five resistors supports multi-point designs
25 W 18 Ω chassis-mount wirewound resistors
These aluminium-housed wirewound resistors are rated at 18 Ω with ±5 % tolerance and 25 W continuous dissipation. They mount directly to a chassis or heatsink using 3.5 mm screw holes. The pack contains five new components for power-circuit prototyping, repair or small-batch production.
Sustained-load thermal behaviour
The aluminium-ceramic-alloy body (27 × 16 × 15.5 mm) conducts heat to the mounting surface, so steady-state temperature rise depends on the thermal resistance of the attached plate. Without forced air or a large heatsink the resistor will reach its rated temperature at full 25 W; derating is required if the mounting interface cannot remove heat at that rate.
Single spec that decides fit
The 18 Ω ±5 % value is the critical parameter: the circuit must call for this exact resistance and tolerance. If the design needs a different ohmic value, tighter tolerance or a non-inductive winding, these parts will not meet the requirement.
How it compares
Measured against everything we stock in Passive Components & Solder Supplies, at today’s prices. Recalculated every night.
- Price $9.99
- Typical for this category: the median of 265 items is $9.99.
Specifications
| Product | |
|---|---|
| Brand name | Unique Bargains |
Questions about this item
How much heat does each 25 W aluminium-cased resistor dissipate when running continuously?
Each unit is rated for 25 W continuous power; the aluminium housing and ceramic core are designed to transfer that heat to a mounting plate or cooling surface.
What mounting hardware is required to install these chassis-mount resistors?
You need a flat metal panel with two 3.5 mm clearance holes spaced to match the 53 mm total length, plus screws and thermal compound or a mica washer for thermal contact.
Will the 18 Ω ±5 % value and wirewound construction work in legacy tube-amp bias or vintage power-supply circuits?
The 18 Ω ±5 % tolerance and non-inductive wirewound element suit older designs that specify a 25 W chassis-mount power resistor.
More in Passive Components & Solder Supplies
Similar items
SHURTAPE TECHNOLOGIES, INC. 100526 Red Painter's Tape 48 mm 55 m
- Capacitors
WUQ 525STID-PWD Plastic Transom Mount 600W 10 pin Multisensor passive component
Unique-Bargains 50W 6 Ohm Aluminium Chassis Mount Wirewound Resistor Glod 5pcs
- Plate Chassis Mount…





