We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
I-type 9V battery clip with red and black wires 15cm long

Unique-Bargains

Unique-Bargains 9V Battery Clip I-Type 15cm

SKU CH-RV1F-DN491

I-type 9V battery clip with 15cm red and black leads for DIY soldering

  • Battery typeBattery Converter
  • I-type plastic shell fits standard 9V batteries
  • 15 cm wire length gives flexible placement
  • Red and black leads simplify polarity identification
  • 10 cm stripped and tinned ends ready for soldering
  • Compact 24 x 12 x 7.5 mm buckle saves space

9V Battery I-Type Clip 15cm

This 15cm I-type clip connects a standard 9V battery to a circuit using two tinned leads. The red and black wires simplify polarity identification during assembly. It suits hobbyists, students and technicians building or repairing battery-powered devices.

Makers needing quick 9V power

The clip is ideal for prototyping, DIY electronics and temporary test rigs where a snap-on connector is convenient. It is not suited for permanent installations that demand screw terminals or locking housings. Builders requiring a right-angle exit or a different lead length should consider other styles.

15cm tinned lead length

The stripped and tinned leads measure 15cm, setting the maximum distance between the battery and the board without extension wires. This single dimension decides whether the clip reaches your layout cleanly.

How it compares

Measured against everything we stock in Alkaline & Coin Cell Batteries, at today’s prices. Recalculated every night.

Price $3.99
Cheaper than about 94% of the 190 comparable items (median $18.49).

Specifications

Product
Brand nameUnique Bargains
Power
Battery typeBattery Converter

Questions about this item

How do I connect the 10 cm stripped and tinned leads to my circuit?

Strip the red and black wires if needed, then solder each lead to the matching terminal on your board or connector.

Will the plastic shell or wires need replacement after repeated battery swaps?

The I-type plastic shell and 15 cm wires are rated for normal use; inspect for cracked housing or frayed insulation after heavy handling.

What current limit should I watch for during continuous draw?

The 24 x 12 x 7.5 mm buckle and thin leads suit low-current projects; sustained loads above a few hundred milliamps may overheat the clip.

More in Alkaline & Coin Cell Batteries

Similar items