Unique-Bargains Alligator Clip to Banana Plug Test Lead Cable 3.3ft Pair
Pair of 3.3 ft test leads with alligator clips and 4 mm banana plugs for quick circuit connections
- 3 ft length gives ample reach for bench work
- 2 mm wire diameter handles typical lab currents
- 4 mm banana plugs fit standard multimeter jacks
- 6 mm alligator opening grips component leads securely
- Insulated boots protect against accidental shorts
Electrical Test Lead Cable
This pair of alligator-clip-to-banana-plug cables connects bench instruments to components or circuit nodes. The 3.3 ft length suits bench-top work where a fixed power supply or multimeter feeds a prototype. Hobbyists, students and service technicians can hook and unhook points quickly without soldering.
Replaces Improvised Jumper Wires
Loose hook-up wire with stripped ends slips off terminals and risks shorting adjacent pins. These leads add shrouded 4 mm banana plugs and spring-loaded alligator clips rated to 6 mm jaw opening, so connections stay firm during vibration or probe movement. The upgrade is worth it whenever a test setup is rebuilt repeatedly or must survive handling.
Practical Limits of Banana-Plug Interface
The 4 mm plug diameter fits standard laboratory sockets but will not mate with 2 mm or proprietary connectors found on some handheld meters. The 2 mm conductor cross-section limits continuous current to low-signal or modest-power levels, so high-current automotive loads are outside the safe operating area. The 3.3 ft fixed length cannot be extended without adding resistance and potential failure points.
How it compares
Measured against everything we stock in Meters, Testers & Measuring Tools, at today’s prices. Recalculated every night.
- Price $5.99
- Cheaper than about 95% of the 3,030 comparable items (median $54.99).
Specifications
| Product | |
|---|---|
| Brand name | Unique Bargains |
Questions about this item
Will the 4 mm banana plugs fit my multimeter jacks?
The male banana plugs measure 4 mm in diameter, matching the standard size used on most multimeters and power supplies.
How do I connect the alligator clips without a loose grip?
Open each clip up to 6 mm, seat the jaw squarely on the conductor, then release so the teeth bite cleanly — do not just hook the tip.
When should I replace these test leads?
Replace the pair if the insulation boots crack, the wire strands fray near the plugs, or the clip springs lose tension and slip off.
More in Meters, Testers & Measuring Tools
Similar items
iKKEGOL OBD-II 16Pin Male-Female Extension Cable 100cm
- Black
- Code Readers & Scan…
Pomona Electronics 6729-2 Right Angle Banana Plug CAT III 1000V Red measurement tool
- Assortments & Kits





