Unique-Bargains Aluminum Case Resistor 10W 20 Ohm Wirewound Rod Post
A 10 W wirewound resistor with a 20 Ω rating and an aluminum case for heat dissipation
- Key featuresAluminum Case Resistor 10w;Aluminum Housed Resistor 10w;wire
- 10 W power rating handles demanding circuits
- Aluminium housing dissipates heat for stable performance
- 20 Ω ±5 % precision suits LED converters
- Rod terminals with 2.5 mm screw holes enable secure mounting
- Compact 1.9 cm body fits tight board layouts
Aluminum housed 10 W 20 Ω resistor
This wire-wound resistor comes in an aluminium case that acts as its own heat sink. Rated at ten watts and twenty ohms with a five-per-cent tolerance it suits LED converters, speed-control circuits and similar power-dissipation tasks. The gold-coloured body measures 1.9 cm long and weighs 6 g.
Rod terminals with 2.5 mm screw holes
Two rod posts each 7.7 mm long include 2.5 mm clearance holes spaced 14 mm centre-to-centre so they accept M2.3 or #2 hardware. The through-hole rods allow direct PCB mounting or chassis bolting without extra brackets. No additional connector or socket is required.
Passive aluminium-case cooling
The aluminium housing transfers heat directly to the surrounding air so the resistor runs within its ten-watt rating without forced airflow. Silent operation is inherent because there are no moving parts. Power draw is determined solely by the applied voltage across the twenty-ohm element.
How it compares
Measured against everything we stock in Passive Components & Solder Supplies, at today’s prices. Recalculated every night.
- Price $4.99
- Cheaper than about 90% of the 265 comparable items (median $9.99).
Specifications
| Product | |
|---|---|
| Brand name | Unique Bargains |
Questions about this item
At what power level does the 10 W aluminum-housed resistor reach its thermal limit?
The resistor is rated for 10 W continuous dissipation; its aluminum case transfers heat away from the wire-wound element so the thermal limit is reached at the rated 10 W.
How hot does the case get and what noise does it make when run at 10 W all day?
The aluminum case becomes hot to the touch at full 10 W load but the resistor has no moving parts and therefore produces no audible noise.
What mounting hardware must I already have to secure the 2.5 mm screw holes spaced 14 mm apart?
You need #2 or M2.3 nuts and bolts to fasten the resistor through its 2.5 mm mounting holes set 14 mm center-to-center.
More in Passive Components & Solder Supplies
Similar items
Unique-Bargains 100uF 400V 105C Aluminum Electrolytic Capacitor 3pcs
WUQ 525STID-PWD Plastic Transom Mount 600W 10 pin Multisensor passive component
Unique-Bargains 25W 30 Ohm Aluminium Chassis Mount Wirewound Resistor Gold
- Cool plate Chassis…
Unique-Bargains 25W 7.5k Ohm Wirewound Resistor Aluminium Housing Green 1pcs
- Cool plate Chassis…





