Unique-Bargains Aluminum Case Resistor 5W 90 Ohm Wirewound 2 Pcs
Wirewound aluminum-housed resistors rated at 5 W and 90 Ω, supplied as a pair
- Key featuresAluminum Case Resistor5w;Aluminum Housed Resistor 5w;wire wo
- 5 W wirewound power handles LED loads reliably
- 90 Ω ±5 % tolerance suits converter speed control
- Aluminium housed body dissipates heat without a fan
- 9 cm long, 23 mm leads fit tight boards
- Two pieces per pack for spares or dual circuits
Resistor for LED and Converter Use
Two 90 ohm wirewound resistors rated at 5 watts each. They suit hobbyists and technicians replacing load resistors in LED circuits or converter speed controls. The aluminium housing provides insulated thermal management. Pack contains two pieces.
Upgrade from Lower Power Parts
These replace smaller axial or carbon-film resistors that cannot dissipate 5 watts continuously. The jump is worth it when a circuit demands sustained power handling without overheating. The wirewound construction and metal case give stable resistance under load.
Capacity and Thermal Limits
Each unit handles 5 watts at 90 ohms with a 5 percent tolerance. Body length is 1.9 cm and lead length is 23 mm. They comfortably handle continuous dissipation in free air. They run out when ambient temperature or enclosure restricts heat flow from the aluminium case.
How it compares
Measured against everything we stock in Passive Components & Solder Supplies, at today’s prices. Recalculated every night.
- Price $5.99
- Cheaper than about 70% of the 265 comparable items (median $9.99).
Specifications
| Product | |
|---|---|
| Brand name | Unique Bargains |
Questions about this item
What are the body length and wire length of each 90 ohm resistor?
The main body is 1.9 cm (0.75 inches) long and the connection wires measure 23 mm (0.9 inches).
How do I solder these wirewound resistors without damaging the aluminum case?
Use a temperature-controlled iron, apply heat briefly to the wire leads only, and avoid prolonged contact with the case to prevent internal insulation breakdown.
When should I replace these 5 watt resistors in an LED converter circuit?
Replace them if the case shows discolouration, the resistance drifts beyond the 5% tolerance, or the wire insulation becomes brittle from repeated thermal cycling.
More in Passive Components & Solder Supplies
Similar items
WUQ 525STID-PWD Plastic Transom Mount 600W 10 pin Multisensor passive component
Unique-Bargains 50W 4 Ohm Aluminium Chassis Mount Wirewound Resistor Green
- Plate Chassis Mount…
Unique-Bargains 50W 1.5k Ohm Chassis Mount Wirewound Resistor Green
- Plate Chassis Mount…





