Unique-Bargains Cable Tie Mount Base Holder 100 Pcs White 15 x 10 x 7mm

Cable Tie Mount Base Holder — 100 pieces

This pack supplies one hundred white plastic saddle mounts that accept cable ties up to five millimetres wide. Each mount measures fifteen by ten by seven millimetres and weighs fifty-five grams total. The three-millimetre screw hole lets you secure the base to panels, walls or vehicle trim before strapping cables in place.

Replaces adhesive-backed clips

Screw fixation prevents the mount from peeling away under vibration or temperature swings, a common failure mode of sticky pads. The jump is worth it when cables run along chassis rails, engine bays or equipment racks where a permanent mechanical anchor outperforms temporary adhesive.

Limited to surfaces that accept a three-millimetre

Hollow plastic trim, thin sheet metal or brittle composite panels may crack or strip when drilled. The saddle geometry also requires enough clearance for the tie head to pass through, so extremely tight looms or congested harnesses may not accommodate the mount profile.